How to reset 2Wire 2701HG-G Qwest Router
Here you will find how to reset the 2Wire 2701HG-G Qwest router.
- 2Wire 2701HG-G Qwest Router
- Login to 2Wire 2701HG-G Qwest Router
- Manual for 2Wire 2701HG-G Qwest Router
- 2Wire 2701HG-G Qwest Factory Settings
When is resetting of the 2Wire 2701HG-G Qwest router needed?
- 1. When you can not access the router by IP address or your username and password do not match.
- 2. When you want to remove all previously configured settings.
- 3. When the router does not work as you expect.
Reset the 2Wire 2701HG-G Qwest router
The reset button is located on the back of the router. Use a sharp tool eg. paperclip or a pen to press the button. Press and hold the button for 20 seconds, the router will restart and reset to the factory settings.
Note! After 2Wire 2701HG-G Qwest has been reset, all settings that apply to the connection and the network must be reconfigured. After resetting, the router will restart. On initial start-up, the factory settings are recharged and the computer loses connection to the router for about 30 seconds. You can then login the setup interface of the 2Wire 2701HG-G Qwest router and reconfigure the network.
Resetting the 2Wire 2701HG-G Qwest router problems
If resetting the router has failed, you probably did not hold the reset button for long enough, try again.
Security of 2Wire 2701HG-G Qwest after reset
Change the 2Wire 2701HG-G Qwest Default Password
After resetting the 2Wire 2701HG-G Qwest router, the device receives a predefined password from the manufacturer known to everyone and written on the device’s box. Hackers know this and always try to access your network with these predefined passwords. All Security Professionals recommend you to change the default password immediately after resetting the 2Wire 2701HG-G Qwest router.
Change 2Wire 2701HG-G Qwest Default IP Address
After resetting the 2Wire 2701HG-G Qwest, the router receives the first possible address (192.168.0.1), change it to 192.168.0.99 or something similar that you can easily remember, if possible. You can change the IP addresses that are used to a group reserved for private networks. This will protect your 2Wire 2701HG-G Qwest router from malicious actions (cross-site request forgery CSRF) that most often attack through the user's browser and try to get to the router by using IP addresse set as default.
Change 2Wire 2701HG-G Qwest SSID (Wifi name)
After resetting 2Wire, the router receives the SSID (Wifi name) by default. These predefined names from the manufacturer are known and limited in number, enabling scanning for them to be quickly and easily detect the network and its parameters when match. You must change the network name immediately after resetting the device, also the regular replacement makes it difficult to identify the network and protects from a subsequent attack.