How to reset A-Link RR24AP Router
Here you will find how to reset the A-Link RR24AP router.
- A-Link RR24AP Router
- Login to A-Link RR24AP Router
- Manual for A-Link RR24AP Router
- A-Link RR24AP Factory Settings
When is resetting of the A-Link RR24AP router needed?
- 1. When you can not access the router by IP address or your username and password do not match.
- 2. When you want to remove all previously configured settings.
- 3. When the router does not work as you expect.
Reset the A-Link RR24AP router
The reset button is located on the back of the router. Use a sharp tool eg. paperclip or a pen to press the button. Press and hold the button for 20 seconds, the router will restart and reset to the factory settings.
Note! After A-Link RR24AP has been reset, all settings that apply to the connection and the network must be reconfigured. After resetting, the router will restart. On initial start-up, the factory settings are recharged and the computer loses connection to the router for about 30 seconds. You can then login the setup interface of the A-Link RR24AP router and reconfigure the network.
Resetting the A-Link RR24AP router problems
If resetting the router has failed, you probably did not hold the reset button for long enough, try again.
Security of A-Link RR24AP after reset
Change the A-Link RR24AP Default Password
After resetting the A-Link RR24AP router, the device receives a predefined password from the manufacturer known to everyone and written on the device’s box. Hackers know this and always try to access your network with these predefined passwords. All Security Professionals recommend you to change the default password immediately after resetting the A-Link RR24AP router.
Change A-Link RR24AP Default IP Address
After resetting the A-Link RR24AP, the router receives the first possible address (192.168.0.1), change it to 192.168.0.99 or something similar that you can easily remember, if possible. You can change the IP addresses that are used to a group reserved for private networks. This will protect your A-Link RR24AP router from malicious actions (cross-site request forgery CSRF) that most often attack through the user's browser and try to get to the router by using IP addresse set as default.
Change A-Link RR24AP SSID (Wifi name)
After resetting A-Link, the router receives the SSID (Wifi name) by default. These predefined names from the manufacturer are known and limited in number, enabling scanning for them to be quickly and easily detect the network and its parameters when match. You must change the network name immediately after resetting the device, also the regular replacement makes it difficult to identify the network and protects from a subsequent attack.