Actiontec GT704-WGv3 Router

  1. Login to Actiontec GT704-WGv3 Router
  2. Manual for Actiontec GT704-WGv3 Router
  3. Reset Actiontec GT704-WGv3 Router
  4. Actiontec GT704-WGv3 Factory Settings

How to login to the Actiontec GT704-WGv3 router interface

To login the router with the preconfigured default data, follow the guide to Actiontec GT704-WGv3 login.

User’s manual for Actiontec GT704-WGv3 Router

Quick and easy solutions to your Actiontec GT704-WGv3 router problems can be found in the user's manual.

How to reset the Actiontec GT704-WGv3 router to the factory settings

If the router does not work the way you want, you can not access the router by IP address or the username and password do not match, you will probably need to reset it, following the Actiontec GT704-WGv3 reset instructions.

Default settings for the Actiontec GT704-WGv3 router

The router's default settings are those which the router possess at it’s first launch. They include an IP address, username and password. This data will be required, if you apply a reset the Actiontec GT704-WGv3 to factory settings.

How to Protect Your Actiontec GT704-WGv3 Router

Change the Actiontec GT704-WGv3 Default Password

Most Actiontec routers come with an elementary password known to everyone and written on the device's box. Hackers know this and always try to access your network with these preconfigured passwords. So when you first connect to you new Actiontec GT704-WGv3 router’s interface, the most important thing is to change your initial password. You may not have to use this password often, so be sure to have it written in a safe place. Without it, the only way to access the router may be to reset the device’s factory settings.

Change Actiontec GT704-WGv3 Default IP Address

The routers take the first possible address (192.168.0.1), change it to 192.168.0.99 or something similar to that, which you can easily remember. You can change the IP addresses, that are used to a group reserved for private networks. This will protect your Actiontec GT704-WGv3 router from attacks by fake requests (cross-site request forgery CSRF), that most often attack through the user's browser and try to access the router by using IP addresses set as default.

Change Actiontec GT704-WGv3 SSID (Wifi name)

Most Actiontec routers have the default SSID. These names are known and limited in number, enabling to scan quickly and easily for them, and to easily detect the network and its parameters if there is a match. The initial replacement of the network name, as well as regular replacement, make it difficult to identify the network easily and a also make it difficult for a subsequent attack.

Position the Actiontec GT704-WGv3 in a good place

Position your router near where you spend the most time on the web.
A few tips for positioning the Actiontec GT704-WGv3 router:

- Place the router close to the center of your home.
- Do not put it on the floor but on a desk, table or shelf.
- Do not place it in the immediate vicinity of a wall that will take the signal.
- Do not place it near other devices that emit wireless frequencies, such as microwave ovens or wireless phones.

If your router has external antennas, you need to be sure that they are pointing in the right direction to optimize range and performance.