RadioLabs O2Storm Router

  1. Login to RadioLabs O2Storm Router
  2. Manual for RadioLabs O2Storm Router
  3. Reset RadioLabs O2Storm Router
  4. RadioLabs O2Storm Factory Settings

How to login to the RadioLabs O2Storm router interface

To login the router with the preconfigured default data, follow the guide to RadioLabs O2Storm login.

User’s manual for RadioLabs O2Storm Router

Quick and easy solutions to your RadioLabs O2Storm router problems can be found in the user's manual.

How to reset the RadioLabs O2Storm router to the factory settings

If the router does not work the way you want, you can not access the router by IP address or the username and password do not match, you will probably need to reset it, following the RadioLabs O2Storm reset instructions.

Default settings for the RadioLabs O2Storm router

The router's default settings are those which the router possess at it’s first launch. They include an IP address, username and password. This data will be required, if you apply a reset the RadioLabs O2Storm to factory settings.

How to Protect Your RadioLabs O2Storm Router

Change the RadioLabs O2Storm Default Password

Most RadioLabs routers come with an elementary password known to everyone and written on the device's box. Hackers know this and always try to access your network with these preconfigured passwords. So when you first connect to you new RadioLabs O2Storm router’s interface, the most important thing is to change your initial password. You may not have to use this password often, so be sure to have it written in a safe place. Without it, the only way to access the router may be to reset the device’s factory settings.

Change RadioLabs O2Storm Default IP Address

The routers take the first possible address (, change it to or something similar to that, which you can easily remember. You can change the IP addresses, that are used to a group reserved for private networks. This will protect your RadioLabs O2Storm router from attacks by fake requests (cross-site request forgery CSRF), that most often attack through the user's browser and try to access the router by using IP addresses set as default.

Change RadioLabs O2Storm SSID (Wifi name)

Most RadioLabs routers have the default SSID. These names are known and limited in number, enabling to scan quickly and easily for them, and to easily detect the network and its parameters if there is a match. The initial replacement of the network name, as well as regular replacement, make it difficult to identify the network easily and a also make it difficult for a subsequent attack.

Position the RadioLabs O2Storm in a good place

Position your router near where you spend the most time on the web.
A few tips for positioning the RadioLabs O2Storm router:

- Place the router close to the center of your home.
- Do not put it on the floor but on a desk, table or shelf.
- Do not place it in the immediate vicinity of a wall that will take the signal.
- Do not place it near other devices that emit wireless frequencies, such as microwave ovens or wireless phones.

If your router has external antennas, you need to be sure that they are pointing in the right direction to optimize range and performance.